Removal and Replacement

Steering angle sensor -G85-, removing and installing

Removing
- Turn wheels to straight ahead position.
- Removing airbag module and steering wheel.
- Remove lower stowage compartment.
- Take out covering in footwell.





- Remove bolts -1-.
- Take off handle for height and reach adjustment -5-.
- Remove bolts -2-, -3- and -4-.
- Take off lower steering column switch trim.





- Take off upper steering column switch trim -1-.





The steering angle sensor -G85- is installed in a housing -1- together with the coil connector.





- Disconnect connectors -1- and -2-.





- Carefully lift locking lugs (arrows) and pull off steering angle sensor -G85-.

Installing
The steering angle sensor -G85- must be in its centered position before installing.
- Install steering angle sensor -G85- until lugs engage.
- Remove transportation protection.





- A yellow mark must be visible in hole (arrow -1-).
- The marks (arrows) must also align.

Make sure it does not move from centered position.
Further installation in reverse order
- Installing airbag module and steering column.
- Perform steering angle sensor -G85- basic settings.