Electrical Check of Mark 60

Electrical check of Mark 60





Special tools and equipment
^ V.A.G 1598/36 Adapter
^ V.A.G 1594 A Adapter set
^ V.A.G 1526 A Hand multimeter
^ V.A.G 1921 Pliers
^ V.A.G 1598 A Test box

^ For vehicles on which the On Board Diagnostic (OBD) does not give any indication of the source of the malfunction. Work through the complete electrical check.
^ For vehicles on which the OBD provides a direct indication of the source of the malfunction. Only carry out the test steps recommended in the DTC table (directed entry). Diagnostic Trouble Code (DTC) Table

Test prerequisites
^ Switch ignition and electrical consumers off before commencing the check (headlights, lighting, fans ...).
^ Fuses must be OK (remove fuses from fuse holder to check).
- Pull fuse holder out of cable channel.





- Release ABS Control Module (w/EDL) -J104- connector -arrow 1- and pull off -arrow 2-.





- Connect test box V.A.G 1598/36 -1- to multi-pin connector of ABS control module (w/EDL) -J104- -2-.

The specified values are matched to the V.A.G 1526 and are not necessarily applicable for other test modules.