Glass Panel For Sunroof, Installing

Glass Panel For Sunroof, Installing

Panel must be installed in zero position (panel closed).

Zero position:







Marking - arrow - on upper part of rear guide - 1 - must be located on both sides between markings dimension - a - at slotted guide rail - 2 -.

Slotted guide rail - 2 - must be engaged in guide rail (cannot be moved by hand).

If this is not case, adjust parallel movement
- Insert sunroof panel from above and screw in securing bolts (guide rail/panel).
- Slightly tighten securing bolts (Torx T25).







- Adjusting glass panel for sunroof (height adjustment) => Glass panel for sunroof (height adjustment), adjusting

NOTE:
- Tighten securing bolts after panel height adjustment (4.5 Nm).
- For vehicles up to calender week 35 2002 (CW 35/02), install lower trim and upper trim after adjusting panel height.

Vehicles from calender week 36 2002 (CW 36/02) on
In vehicles from calender week 36 2002 (CW 36/02) on, a trim piece is installed in place of a lower trim and an upper trim.

NOTE:
- Trim piece and trim must not be replaced against each other. Clearance for mechanical components is otherwise not guaranteed.
- Install trim piece after panel height adjustment.