Bonded Rubber Bushing For Wheel Bearing Housing (Aluminum), Removing and Installing (AWD)

Bonded rubber bushing for wheel bearing housing (aluminum), removing and installing





Special tools, testers and auxiliary items required
^ - 2 - Puller Kukko 18/0
^ - 3 - Separating device Kukko 17/1
^ Puller for wheel hub 3349
^ Assembly device 3292
^ Press piece 3292/3
^ Assembly device 3293

The bonded rubber mounting in the wheel bearing housing is comprised of two parts. Removing is undertaken in two work sequences.

Pressing out first bonded rubber bushing
^ Bend bonded rubber mounting plate collar over slightly.





^ Install assembly device and tighten spindle.
^ A - Separating device 17 to 75 mm, e.g. Kukko 17/1

The tool blades must be positioned exactly between the bonded rubber mounting collar and wheel bearing housing.

^ Insert pin 3293/1.





^ Install puller for wheel hub 3349 so that the blades slide exactly between the bonded rubber bushing and wheel bearing housing.
^ Turn spindle - 2 -until the bonded rubber bushing lifts slightly off wheel bearing housing.
^ Tighten bolts - 1 -.
^ A - Separating device 17 to 75 mm, e.g. Kukko 17/1





^ Press one of the bonded rubber bushings out by turning hex bolt - 1 -.
^ A - Separating device 17 to 75 mm, e.g. Kukko 17/1
^ B - Puller 17 to 75 mm, e.g. Kukko 18/0

Pressing out second bonded rubber bushing





^ Insert thrust piece 3349/1 and use spindle from 3292.
^ Pull out bonded rubber bushing by tightening the spindle.

Note:
^ Make sure that the tool blades lie completely on the shoulder of the bonded rubber mounting while pulling out.

Installing bonded rubber bushing into wheel bearing housing

Installing bonded rubber bushing is completed in one sequence.





^ Install both bonded rubber bushings together with tool 3293/3.
^ Pull in bonded rubber bushings by turning spindle.