Trunk Lid Lock And Lock Cylinder Carrier, Assembly Overview

Trunk Lid Lock And Lock Cylinder Carrier, Assembly Overview 10.00 -->







1 - Lock cylinder carrier
- Removing:
- Disconnect harness connectors for license plate light, positioning motor for central locking system and switch on lock cylinder.
- Unclip Bowden cable - 5 - from lock. then, Remove nuts - 2 -.
- Now, lock cylinder carrier can be removed from trunk lid.

- Installing:
- Installation is reverse of removal.

2 - Nut
- Qty 4
- 7 Nm

3 - License plate backing
- Press on only on hatched area.
- Replacement part has two foils. first foil covers adhesive surface, second must be removed after installing.

4 - Pop rivet
- Pull in using Pop rivet tongs V.A.G 1765 A

5 - Bowden cable
6 - Nut
- Qty 2
- 7 Nm

7 - Lock
- Removing:
- Remove trim for trunk lid.
- Disconnect harness connector from lock.
- Unclip Bowden cable - 5 -, remove nuts - 6 - and remove lock from trunk lid.

8 - Actuator lever
9 - Motor to unlock rear lid V139
- Removing:
- Remove lock cylinder carrier - 1 -:
- Unbolt motor and remove.

10 - Operating rod
11 - Actuator lever