On-Board Diagnostics (OBD) For Seat Adjustment, Initiating

Seat Adjustment On Board Diagnostic (OBD), Initiating

Test requirements:
- Voltage supply and fuses for the respective system OK.
- To initiate the On Board Diagnostic (OBD) the ignition must be switched on "Terminal 15 on."

NOTE:
- If the display remains blank, check V.A.G 1551 voltage supply according to wiring diagram.
- Additional operating information can be printed out depending on the program by pressing the HELP button of V.A.G 1551.
- The -> button is used for advancing the program sequence.
- The PRINT button is used for switching on the printer (warning lamp in button lights up).

- Connecting Scan Tool. Scan Tool Connecting
- Switch on ignition.
- Switch on printer with Print button (warning lamp in button lights up).
- Press button -1- for "Rapid Data Transfer" mode.

Indicated on display

Rapid data transfer HELP
Enter address word XX

Address word for the seat adjustment: 36

Indicated on display

Rapid data transfer HELP
Enter address word XX

- Press buttons -3- and -6-.

Indicated on display after entering the address word 36.

Rapid data transfer Q
36 - Seat adjustment

- Confirm with -Q- button.

and then the following appears in the display:

Indicated on display

Rapid data transfer
Tester sends the address word 36

The control module identification will be shown on the V.A.G 1551 Scan Tool display, e.g.:

3B1959760XXSeat adjustment FS0001 ->

- Press -> button.

Indicated on display

Rapid data transfer HELP
Select function XX