Diagnostic Trouble Code (DTC) Memory, Checking (Function 02)

Diagnostic Trouble Code (DTC) Memory, Checking (Function 02)

NOTE: DTCs stored in memory along with corresponding malfunction descriptions can only be displayed by initiating the On Board Diagnostic program and checking DTC memory (function 02). The malfunctions are not updated continuously, but only during initiation of the OBD and/or with the function 05, "Erase DTC memory".

- Switch on printer with the PRINT button (indicator lamp in button lights up).

Indicated on display (select function)

Rapid data transfer HELP
Select function XX

- Press buttons 0 and 2 to select function 02, "Check Diagnostic Trouble Code (DTC) memory",

Indicated on display

Rapid data transfer Q
02 - Check DTC memory

- Press -Q- button to confirm input.

The number of stored malfunctions appears in the display.

X DTC recognized! ->

The number of stored DTCs or "No DTC s recognized" appears in the display and are printed out one after another.

- When last DTC has been displayed and printed out, correct malfunctions as described in DTC table. VAG Codes

If "No DTC recognized" is displayed, the program will return to the initial position after pressing -> button.

No DTC recognized! ->

Indicated on display (select function):

Rapid data transfer HELP
Select function XX

If display not indicated as shown:
- End Output (function 06). End Output (Function 06)
- Switch off ignition and disconnect Data Link Connector (DLC).

NOTE:
If DTCs were recognized, follow the sequence below:
1. Correct malfunction.
2. Erase Diagnostic Trouble Code (DTC) memory (function 05).
3. Check Diagnostic Trouble Code (DTC) memory (function 02).