Pump-Injector Unit, Assembly Overview

Pump-Injector Unit, Assembly Overview

- Observe rules of cleanliness Rules for cleanliness
- Always replace sealing rings and O-rings







1. 20 Nm plus an additional 1/4 turn (90 degrees)
- Replace
2. Rocker lever shaft
- With rocker lever
- Removing and installing, Pump-Injector unit.
3. Lock nut, 30 Nm
4. Adjustment screw
- Replace
5. Ball pin
- Replace
6. Pump-Injector unit
7. O-ring
- Replacing, O-ring for Pump- Injector unit.
8. O-ring
- Replacing, O-ring for Pump- Injector unit.
9. O-ring
- Replacing, O-ring for Pump- Injector unit.
10. Heat protection seal
- Replace
11. Circlip
12. Cylinder head
13. Tension block
14. 12 Nm plus an additional 3/4 turn (270 degrees)
- Replace