ATF Level, Topping Up

ATF level, topping up, 09G, 6 Spd. A/T





If no ATF leaks out of overflow pipe - arrow2 - before ATF temperature reaches 40°C, top up the ATF level.

Note: Reinstall the ATF control plug at the latest before the temperature reaches 45°C (50°C for hot climates). If necessary switch off the engine, allow the transmission to cool down and repeat the check.

CAUTION:
- When working in the vicinity of the radiator, ensure sufficient clearance is left for the radiator coolant fan.
- The radiator coolant fan can switch on without prior warning.





- Pry off plug securing cap - arrow - with a screwdriver. Cap locking device will be damaged when removing, therefore always replace cap.
- Pull plug out of filler pipe.





- Fill with ATF using ATF filler tool V.A.G1924 until ATF runs out of level hole.

CAUTION: An insufficient filling with ATF as well as filling to excess affects the function of the transmission.





- Tighten ATF control plug - arrow 1 - (with a new seal) to 27 Nm. ATF check is now completed.

Note: Reinstall the ATF control plug at the latest before the temperature reaches 45°C (50°C for hot climates). If necessary, allow the transmission to cool down and repeat the check.
- Switch off ignition.





- Install plug to filler pipe and secure with a new cap - arrow -.
- Lock cap.

CAUTION: Always replace the cap. The cap secures the sealing plug.

- End function "08 - Read measured value data block" by touching key.
- Tip on function "06 - End output".
- Switch off ignition and disconnect diagnosis cable.
- Install sound insulation.