FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Ignition Switch Lock Cylinder: Service and Repair



Lock Cylinder, Removing And Installing

CAUTION:
Before beginning repairs on the electrical system:
- Obtain the anti-theft radio security code.
- Switch off all electrical consumers.
- Switch off ignition and remove ignition key.
- Disconnect negative ( - ) battery terminal.
- When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified.

Removing

Special tools and equipment
Steel wire, 1.2 mm (0.047 in.) thick
- Disconnect battery.
- Remove upper and lower steering column switch trim.
- Insert ignition key in lock cylinder.
- Turn to "Drive" position.

Position of key in lock cylinder:
1. Position "Stop"
2. Position "Drive"
3. Position "Start"







- Insert wire (approx. 1.2 mm diameter) in drilling next to ignition key -arrow-.







- Release lock cylinder securing lever using wire -2- and remove lock cylinder from steering lock housing.

1. Lock cylinder
2. Wire (approx. 1.2 mm diameter)
3. Securing lever

Installing
- Insert ignition key into lock cylinder.
- Turn to "Drive" position.
- Release securing lever using wire (approx. 1.2 mm diameter) and insert lock cylinder in steering lock housing.
- Remove wire out from lock cylinder and check that lock cylinder is seated properly in steering lock housing.
- Install steering column switches and steering wheel trim.