Multi-Function Transmission Range (TR) Switch, Replacing
Multi-Function Transmission Range (TR) Switch, Replacing
Recommended special tools and equipment
- V.A.G 1331 Torque wrench (5 to 50 Nm)
- T10173 Setting gauge (vehicles with 09G transmission)
Requirements
Vehicles with 01 M transmission
- Selector lever must be in -P- position.
Vehicles with 09G transmission
- Selector lever must be in -N- position.
Continued for all vehicles
- Parking brake must be engaged or else daylight driving lights will be switched on.
- Ignition switched off.
Replace Multi-Function Transmission Range (TR) switch -F125-
- Vehicles with 01 M transmission.
- Vehicles with 09G transmission.
Replacing Multi-Function Transmission Range (TR) switch -F125- (vehicles with 01 M transmission)
NOTE: Multi-function switch is located at rear on transmission.
- Disconnect connector from Multi-Function Transmission Range (TR) switch -F125-
- Remove mounting bolt and retainer.
- Remove Multi-Function Transmission Range (TR) switch.
- Replace O-ring.
Installation is performed in reverse order of removal.
- Tighten bolt to 10 Nm.
- Erase DTC memory of Transmission Control Module (TCM). Diagnostic mode 4: Reset/erase diagnostic data.
- Generate readiness code.
Replacing Multi-Function Transmission Range (TR) switch -F125- (vehicles with 09G transmission)
Removing
- Remove air filter housing.
- Pry off selector lever cable -1- from shift rod -4- using an open-end wrench 10 mm.
- Compress locking mechanism (arrows) and pull selector lever cable out of mounting bracket.
- Disconnect connector -2- from Multi-Function Transmission Range (TR) switch -F125-
- Remove mounting nut -1-
- Remove compression spring -2- and lever -3- from shift rod -4-.
- Carefully bend locking washer hooks -2- back using a screwdriver.
NOTE: If a hook breaks off, replace locking washer.
- Remove mounting nut -1-
- Remove mounting bolts -5-.
- Remove Multi-Function Transmission Range (TR) switch -F125- -4- with washer -3- and locking washer from shift rod -6-
Installing and adjusting
- Connect Multi-Function Transmission Range (TR) switch -F125- (-4-) to shift rod -6-
- Screw in mounting bolts -5- for multi-function switch hand-tight.
- Place setting gauge T10173 on shift rod -2-
- Rotate Multi-Function Transmission Range (TR) Switch -1- until tab on connector engages in groove of adjustment tool.
- Fasten setting gauge T10173 onto shift rod -2- using bolt -3-.
- Tighten mounting bolts (arrows) of Multi-Function Transmission Range (TR) switch.
Tightening torque: 6 Nm
- Remove adjustment tool T10173 from shift rod.
Rest of installation is performed in reverse order of removal.
- Erase DTC memory of Transmission Control Module (TCM). Diagnostic mode 4: Reset/erase diagnostic data.
- Generate readiness code.