ABS ITT Mark 20 IE

Brake light switch, adjusting
Vehicle from m.y. 03.00
- Pull out brake light switch plunger to full extension.
- Keep brake pedal in up position (IMPORTANT! hold pedal up if necessary while installing switch).
- Guide switch through mounting hole (only fits in one position).
- Seat switch fully into opening (pressing plunger against pedal to adjust.
- Seat switch by turning it 45° clockwise. This action also turns the plunger shoe into the correct orientation to make electrical contracts in switch operate as well as locks in plunger adjustment.
- Connect brake light switch connector.
- Operate brake pedal to verify proper function.
- Reinstall lower cover panel.