Instrument Cluster, Coding (Function 07)
Instrument Cluster From 10.00, Coding (Function 07)
Use this function to code the control module with indicator unit in instrument cluster -J285- with the following information:
- Available equipment
- Market version
- Code number for service intervals
- Code number for distance impulse number ("K" number)
Coding
- Connect VAG 1551 scan tool (ST), select operating mode 1 "Rapid data transfer", switch on ignition and input address word 17 "Instrument cluster".
After control module identification and immobilizer identification number are displayed:
- Press -> button.
Indicated on display:
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -7- to select function 07 "Code control module".
Indicated on display:
Rapid data transfer Q
07 - Code control module
- Press -Q- button to confirm input.
Indicated on display:
Code Control Module
Enter code number XXXXX (0-32000)
- Confirm applicable available equipment, model and service interval particulars, determine and enter code number from code table.
1) If more than one type of available equipment is to be entered, then the code numbers must be added together.
Example:
Brake pad wear indicator & seat belt warning: 01 + 02 = 03
NOTE:
- The distance impulse number is a constant used to calculate speed and distance travelled.
- The distance impulse number (K number) can be read using function 10 "Adaptation". Adaptation (Function 10)
Indicated on display:
Code Control Module Q
Enter code number 03202 (0-32000)
- Press -Q- button to confirm input.
Indicated on display (example only):
1C0920901C A4 COMBI INSTR VDO V04 ->
Coding 03202 WSC 00000
- Press -> button.
Indicated on display:
IMMO-IDENT No.: VWZ7Z0V0066808 ->
- Press -> button.
Indicated on display (select function)
Rapid data transfer HELP
Select function XX
Ending function:
- Press buttons -0- and -6- to select function 06 "End output".
Indicated on display:
Rapid data transfer Q
06 - End output
- Press -Q- button to confirm input.