Steering Angle Sensor: Service and Repair

Steering angle sensor G85, removing and installing
- Removing airbag unit and steering wheel.
- Turn wheels to straight ahead position.
- Remove covering in footwell.





- Remove bolts - 1-.
- Remove height and reach adjustment handle - 5-.
- Remove bolts - 2 - , - 3 - and - 4 -.
- Remove lower steering column switch trim.





- Remove upper steering column switch trim - 1.-





The steering angle sensor G85 and coil connector are installed together in a housing - 1 -.





- Disconnect connectors - 1 - and - 2 -.





- Lift hooks - arrows - carefully and remove steering angle sensor G85.

Installing
The steering angle sensor G85 must be set to its centered position before installing.
- Position steering angle sender G85 and push down until the lugs engage.
- Remove transportation protection.





- A yellow mark must be visible in hole - arrow 1 -.
- The marks - arrows - must also align.

Make sure it does not move from center position.

Installation is carried out in reverse sequence of removal.
- Install airbag unit and steering wheel.
- Perform basic setting for steering angle sender G85.