ABS Mark 60

ABS control module, coding
^ All functions which could previously be performed with V.A.G 1551 can also be carried out with the tester VAS 5051.
^ When ABS control module (w/EDL) -J104- is coded with 00000, ABS warning light -K47- and warning light for brake system -K1 18flash. An entry is not made in the DTC memory.
^ The ABS control module (w/EDL) -J104- must be recoded if the vehicle relevant coding is not displayed or the control module has been replaced.

Coding is only possible after the workshop code (WSC) has been introduced into V.A.G 1551.

Test sequence
- Connect V.A.G 1551 scan tool and select (address word 03) brake electronics control module with ignition switched on.
- Establish engine code.





Indicated on display:
- Input 07 for the function "Code control module" and confirm with Q key.





Indicated on display:
- Confirm input with Q key.





Indicated on display:
- Enter the relevant code number for this vehicle and confirm with Q key.

Coding variations.





Control module identification is displayed on display of V.A.G 1551 scan tool.