Electrical/Electronic Components and Installing Locations

Electrical/electronic components and installing locations





1- ABS hydraulic unit -N55
^ Located on left of engine compartment.
^ The ABS hydraulic pump -V64- and the inlet/outlet valves in the hydraulic unit are checked by On Board Diagnostic (OBD)
^ The ABS hydraulic pump -V64- and valve block must not be separated from one another
^ When changing the hydraulic unit, always seal the old part with the plugs from the repair set Part No. 1 HO 698 311 A

2- ABS Control Module (w/EDL) -J104
^ Location- on hydraulic unit on left of engine compartment
^ Checked by On Board Diagnostic (OBD)
^ Do not disconnect multi-pin connector before successfully completing OBD. Switch ignition off before separating connection.

Vehicles with ABS/ESP only
- When the ABS Control Module (w/EDL) -J104- is replaced, a zero compensation must be performed
- Initiate basic settings, Perform display group numbers 060, 063 and 066