ABS Mark 60

Anti-lock brake system (ABS) Mark 60, Vehicles 10.00 >
The following versions of the ABS Mark 60 are installed in this vehicle:
^ ABS
^ ABS/EDL/ASR
^ ABS/EDL/ASR/ESP

General information on ABS Mark 60





1- Brake booster
2- Hydraulic unit
3- ABS control module - 3 -, 47-pin (screwed to hydraulic unit - 2 - ). form one unit.

Separating them is only possible when removed. On both ends of the connector, there are two 4.8 mm wide contacts.

The ABS brake system is divided diagonally. The brake booster is a pneumatic type and the vacuum is provided by brake booster.

For vehicles from m.y. 12.01, the mechanical brake assist is installed. It's integrated in the brake booster for the use within the system as special equipment. This can be recognized by the replacement part number.

Repairing the mechanical brake assist is not possible. The brake booster must be replaced complete.

Vehicles with ABS Mark 60 have no mechanical brake pressure regulator. A specially designed software in the control module controls the rear axle brake pressure regulator.

Malfunctions in the ABS systems do not influence the brake system and booster. The conventional braking system remains functional even without ABS.





The hydraulic unit - a - and control module - b - (47 pin) form one component. Separating is only possible when removed.

New control modules service via the replacement parts are not coded and require coding after installation.





Identification characteristic of the ABS Mark 60

Dimension a = 100 mm

1- Control module, 47-pin (screwed to hydraulic unit). Two 4.8 mm wide contacts are located at both ends of the connection.