Rear Catch - Electro/Hydraulic, Assembly Overview

Convertible Top Rear Catch - Electro/Hydraulic, Assembly Overview







1. Convertible top catch
- Removing:
- Remove side trim panel.
- Open convertible top or work from inside of vehicle with top closed.
- Disconnect electrical connector - 6 -.
- Remove bolts/screws - 3 -.
- Installing:
- Install bolt/screw - 3 - and tighten lightly.
- Connect electrical connector - 6 -.
- Align module for convertible top catch.
- Close convertible top if decided to open it previously.
- When convertible top has engaged tighten bolts/screw - 3 -.
- Then perform functional check.
2. Washer
- Qty. 7.
3. Bolt/screw
- 10 Nm.
- Qty. 7.
4. Cable for emergency release
5. Servo motor
6. Electrical connector
7. Micro switch (convertible top closed)
8. Micro switch (convertible top open)