Rear Lid Lock, Removing and Installing (Convertible)

Rear Lid Lock, Removing and Installing (Convertible)







1. Lock
- Removing:
- Removing tailgate trim.
- Disconnect connector on lock.
- Unclip operating rod --, unscrew bolts -- and take lock off tailgate.
2. Bolt
- 23 Nm
3. Connector
4. Operating rod
5. Rear lid
6. Pull rod (USA)
7. Lever (USA)
8. Emblem
- Upper part for access to lock cylinder
- remove
- Remove carrier with lock cylinder.
9. Carrier with lock cylinder
- With lock cylinder and micro switch
10. Bolt
- 3 Nm
- Qty. 3
11. Bolt
- 5 Nm
- Qty. 3
12. Micro switch
13. Securing clip
14. Bolt
15. Retaining plate
- With remote release motor
16. Remote release motor
17. Connector
18. Bolt
- 23 Nm
19. Lock plate
- Adjusting - within oversized holes
- Removing:
- Remove load sill trim.
20. Spring (USA)
21. Nut (USA)
22. Shaft (USA)