Power Trunk / Liftgate Lock Actuator: Locations

Rear Lid Lock, Removing And Installing







1. Lock cylinder housing
2. Handle
- Remove bolt , disconnect connector for switch and remove handle from lid.
3. Tailgate/trunk lid release switch E165
4. Bolt
- 7 Nm
5. Carrier plate
6. Operating rod
7. Nut
- 7 Nm
8. Tailgate/trunk lid release motor V139

- Removing
- Disconnect connector from motor.
- Unclip operating rod from lock cylinder housing.
- Unclip operating rod from motor for rear lid release.
- Remove hex nuts and remove carrier plate .
- Remove motor for rear lid release from carrier plate.

9. Operating rod
10. Bolt
- 22 Nm
11. Lock

- Removing
- Remove lid trim.
- Disconnect connector from lock.

12. Rear lid
13. Actuator lever with linkage clip