Power Trunk / Liftgate Lock Actuator: Locations

Rear Lid Lock, Removing And Installing (Jetta)







1. Lock cylinder housing
2. Handle
- Remove bolt , disconnect connector for switch and remove handle from lid.
3. Switch for rear lid release E165
4. Rear Lid
5. Lock
- Disconnect connector from lock.
6. Hex nut
- 7 Nm
7. Actuator lever with linkage clip
8. Motor for rear lid release V139
- Disconnect connector from motor.
- Remove nuts and remove carrier plate .
- Remove motor for rear lid release from carrier plate.
9. Actuator lever
10. Hex nut
- 7 Nm
11. Actuator rod
12. Support bracket
13. Actuator rod
14. Bolt
- 7 Nm