Toe on Rear Axle (Front Wheel Drive Vehicles), Adjusting

Toe on rear axle (front wheel drive vehicles), adjusting
If a value lies outside the tolerances, check trim height and balance if necessary.

The total toe for the rear axle is not adjustable.

Only by moving the mounting bracket is it possible to adjust the individual toe evenly.

If measured values are outside the allowable tolerances the axle beam must be checked for damage and replaced if necessary.
- Loosen all bolts on mounting brackets - 1





- Slide mounting bracket - 1 - laterally.
2 - Rear axle beam

- Tighten bolts to 75 Nm.
- Always use new bolts!