Rear Spoiler Without Rear Lid Change, Removing and Installing

Rear Spoiler Without Rear Lid Change, Removing And Installing

Removing
- Pull cutting wire sideways underneath spoiler as well as into two pulling handles from Cutting tool V.A.G1351







- Cut spoiler free following direction of - arrows -, until cutter reaches screws on external drilled holes
- On center of spoiler base, cut without restraints
- Remove attaching screws

Installing

NOTE:
- When reusing an undamaged rear lid, avoid removing all adhesive residual material on lid
- Residual material acts as an adhesive base for newly applied adhesive sealant

- Install stoplight into spoiler.
- Install spoiler