Evaporative Emissions (EVAP) System, Assembly Overview

Evaporative Emissions (EVAP) system, assembly overview





Engine codes BEV, BGD
1. Tank flap unit
2. Fuel tank
3. Fuel delivery unit
4. Intake hose
5. Throttle valve control module -J338
6. Intake manifold upper part
7. Fuel rail with injectors
8. Fuel filter
^ Installed position: Arrow points in direction of flow
^ With fuel pressure regulator
9. EVAP canister purge regulator valve -N80-
^ On right in engine compartment above wheelhousing liner
^ Installed position: Arrow points in direction of flow
^ Valve will be activated by engine control module (pulsed)
10. Gravity valve
11. Pressure retention valve
^ For fuel tank breather
^ Checking; Refer to Fig. 3
12. Change-over valve
^ Checking; Refer to Fig. 2
13. EVAP canister
^ In right rear wheelhousing, behind wheelhousing liner
14. Leak Detection Pump (LDP) -V144
^ In right rear wheelhousing, behind wheelhousing liner
^ Valve will be activated by engine control module (pulsed)
15. Air filter for leak detection pump