6 Speed Automatic 09G

Shift lock solenoid -N110-, removing and installing

Removing
- Check whether a coded radio is installed. If so, obtain anti-theft coding.
- Move selector lever to position "R".
- With ignition switched off disconnect battery Ground strap.
- Remove selector mechanism and printed circuit board cover.





- Disconnect connector (arrow) off Shift lock solenoid -N110-.
- Pull rod upward and move selector lever to position "P" holding rod in upward position.
- Raise vehicle.





- Loosen double clamp -A- and slide to rear.
- Remove tunnel bridge -B- located beneath exhaust system.
- Remove heat shields -C- and -D-.





- Remove 4 nuts (arrows -A-).
- Remove 2 bolts (arrows -B-).
- Carefully slide cover forward over selector lever cable.

Note: Do not damage protective covering when doing this.





- Unclip Shift lock solenoid -N110- from retainer (arrows -A-).
- Pull Shift lock solenoid -N110- out of pawl (arrow -B-).
- Take Shift lock solenoid -N110- out downward.

Installing
Install in reverse order. When doing this note the following:





- Hook Shift lock solenoid -N110- into pawl (arrow -B-).
- Clip Shift lock solenoid -N110- into retainer (arrows -A-).
- Bolt cover with bonded seal onto selector lever housing.

Note: Ensure seal is positioned correctly.





- Tighten nuts (arrows -A-).
- Tighten 2 bolts (arrows -B-).
- Reconnect exhaust system and install tunnel bridge.
- Install selector mechanism and printed circuit board cover.
- Install center console.
- Connect battery Ground strap.
- Check selector mechanism.
- Enter radio code.
- Initialize power windows, set correct time on clock.