4 Speed Automatic 01M

Removing:

CAUTION!
^ Before working on the electrical system, obtain radio security code and disconnect battery Ground (GND) strap.
^ When reconnecting battery, always check operation of vehicle equipment such as radio, clock, and power windows according to Owner's Manual.
^ Push down sleeve on selector lever.
^ While depressing knob in handle, remove selector lever handle by pulling upward.
^ Carefully pry off cover for selector lever housing at left and right rear and remove,
^ Remove center console and arm rest if installed.
^ Disconnect locking cable from shift mechanism locking lever.
^ Cut cable tie -1- at selector lever housing.

CAUTION!
Do not damage wiring harness.

^ Using screwdriver, carefully pry out retainers for wiring harness and electrical connector -3- from selector lever housing.





^ Disconnect electrical connectors for selector lever lock solenoid -4- and selector lever position display -5-.
^ Carefully pry at four corners -6- and remove. Be careful not to damage contact spring for selector lever position display.
^ Remove locking segment -2 bolts).
^ Move selector lever to "1".
^ Remove retaining bracket -7- (2 nuts).
^ Remove solenoid bolts -8- (Qty. 2).
^ Remove front selector mechanism nuts (Qty. 2).
^ Lift vehicle.





^ Disconnect exhaust system at double clamp -A-. Remove front bracket for exhaust pipe if necessary.
^ Remove cross support -B- below exhaust system.
^ Remove heat shield -C-.
^ Remove heat shield -D-.
^ Remove rear bolts for selector housing.
^ Support selector mechanism .

CAUTION!
Do not bend or kink selector lever cable.

^ With selector lever in "1" remove solenoid with locking pin and spring from selector lever housing (move selector lever slightly back and forth if necessary).

Installing

Install components in reverse order of removal.
^ Adjusting locking cable.
^ Ignition key removal lock, checking.
^ Selector mechanism, checking.