Sunroof Glass Panel, Removing and Installing

Sunroof Glass Panel, Removing And Installing

Removing
- Slide sun protection toward rear.
- Tilt sunroof open.







- Unclip lower trim - 2 - in front area to vehicle center and unhook at rear.
- Unclip upper trim - 1 - at front and in center and disengage at rear.







- Remove securing bolts (Torx bolt insert T25; 4.5 Nm).
- Remove sunroof upward.

NOTE: Sunroof must not be driven into "opened" position with glass panel removed because the rain channel is no longer pressed down by the glass panel and may be wedged in roof.

Installing

NOTE: Panel must be installed in zero position (panel closed)

Zero position:







Marking - arrow - on upper part of rear guide - 1 - must be located on both sides between markings dimension - a - at slotted guide rail - 2 -.

Link guide - 2 - must be engaged in guide rail (cannot be moved by hand).

If this is not the case, adjust parallel movement.







- Insert sunroof panel from above and screw in securing bolts (guide rail/panel).
- Slightly tighten securing bolts (Torx T25).

NOTE: Tighten securing bolts after panel height adjustment (4.5 Nm).