Hydraulic Pump, Removing and Installing

Hydraulic Pump, Removing And Installing

CAUTION:
- Hydraulic system is sensitive to any ingress of dirt.
- As soon as system is opened, corresponding components must be covered so that no dirt can enter hydraulic system.
- Before working on electrical system Disconnect battery ground (GND) strap.

Removing

NOTE: Obtain radio code before disconnecting battery.

- Disconnect Ground (GND) strap from battery
- Remove left luggage compartment trim







- Disconnect harness connector - 5 - from Convertible Top Hydraulic Pump V118.
- Loosen toggle bolt - 1 - so that residual pressure can escape the system, then tighten again.
- Mark hydraulic lines - 3 - before disconnecting. Remove Torx bolts - 2 - (7 Nm).
- Carefully pull hydraulic lines - 3 - out of openings.
- Remove hex nut - 4 - (5 Nm).

Installing
Installation is performed in the reverse order of removal.

NOTE:
- Check for damage and proper fitting of O-rings when installing hydraulic lines.
- After installation of hydraulic pump, hydraulic system must be filled and bled again.
- After connecting battery, vehicle options (radio, clock, electric window regulator) must be checked according to repair manual and/or user manual.