Mirror Turn Signal Light, Removing and Installing

Mirror Turn Signal Light, Removing And Installing

NOTE:
- The mirror turn signal lamp in the rear mirror is a long-lasting light emitting diode (LED) installed, not a conventional light bulb.
- If damaged, the entire turn signal must be replaced.

Removing
- Switch off ignition and all electrical consumers and remove ignition key.







Drivers Exterior Mirror Turn Signal Lamp L131 and Front Passengers Exterior Mirror Turn Signal Lamp L132 are installed in respective rear mirror housing - arrow -.

Perform the following work to remove mirror turn signal lamp:

- Remove mirror glass.
- Remove mirror housing.







- Remove bolt - 1 - inside of mirror housing and unclip catch - arrow -.







- Swing mirror turn signal lamp - 1 - in - direction of arrow - and remove.

Installing







- Install mirror turn signal lamp - 1 - into mirror housing - 2 - as shown - arrows - and swing in - direction of arrow -.







- Clip catch - arrow - and tighten bolt - 1 - to 1 Nm.

The rest of the installation follows the reverse of the removal procedures.