Hood Shock / Support: Service and Repair

Gas-filled Strut, Venting







- Clamp gas-filled strut in vice area - x - = 50 mm (2 in.).

CAUTION: Clamping must only be done in this area, otherwise there is a risk of an accident.

- Using saw, cut into cylindrical part of strut at point within first third of cylinders length (measured from cover edge at piston rod end of cylinder).

NOTE:
- Always wear eye protection when performing this procedure.
- Cover the area of the sawn-off portion with a clean rag.
- Dispose of fluid and cleaning rag in a proper manner.