Front Axle

ABS system on front axle, removing and installing

Note: Removing and installing ABS system parts is identical for FS 111 and EN 3 brake calipers.

1. ABS speed sensor
- Before inserting sensor, clean mounting hole inner surface and coat with lubricating paste G 000 650
- Checked by On Board Diagnostic (OBD)
2. Wheel bearing housing
3. Hex socket head bolt, 8 Nm (70 inch lbs.)
4. Splash plate
5. Hex bolt, 10 Nm (62 inch lbs.)
6. Wheel bearing
- Replace each time after removing
- Pressing out and in
7. Phillips-head screw
8. Brake disc
9. Wheel hub with rotor
- Pressing out and in
10. Circlip