Parts of EVAP Canister System, Removing and Installing

Parts Of EVAP Canister System, Removing And Installing







1 From Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-*
2 Seal
- Replace if damaged
3 Vent line
4 Connection piece
5 Connector
- 3-pin
6 Vacuum line
- to throttle valve control module, item 5
7 Leak detection pump (LDP) -V144-*
- Under wheel housing liner in rear right wheel housing
8 Connection hose
- Pressure side
9 3 Nm
10 Air filter for diagnostic pump
11 Connection hose
- Intake side
12 Bracket
13 10 Nm
14 EVAP canister
- Under wheel housing liner in rear right wheel housing