ABS Mark 60

Diagnostic Trouble Code (DTC) table

Note:
- When beginning On Board Diagnostic (OBD) troubleshooting of the vehicle control modules, always start with function "Automatic test sequence" by pressing keys 0 and 0 because the control modules are interconnected with a data bus wire. This checks the DTC memories of the control modules in the vehicle.
- All the possible DTCs which can be recognized by the ABS control module (w/EDL) -J104- and printed-out on V.A.G. 1551 or VAS 5051.
- DTC code appears (in the "Rapid data transfer" mode) only on the print-out.





Example:

- The 5 digit P code which may appear next to the DTC code, is for use with the On Board Diagnosis (OBD) and may be disregarded.
- The 3 digit DTC type code is a data code and may be disregarded, but the DTC type text is of use.
- Before replacing components indicated as being faulty, check all the appropriate connectors, wiring and Ground connections using the wiring diagram Electrical Wiring Diagrams, Troubleshooting & Component Locations binder.
- On completion of repairs always check the DTC memory with V.A.G. 1551 scan tool or the VAS 5051 and erase.
- Carry out road test exceeding 20 km/h (13 mph).
- After the road test check DTC memory again.