Trunk / Liftgate Lock Cylinder: Service and Repair

Lock Cylinder Housing, Removing And Installing







1 - Handle
2 - Guide sleeves
3 - Handle recess
4 - Seal
5 - Retaining clip
6 - Pin
7 - Circlip
8 - Spring
9 - Seal
10 - Lock cylinder housing
- Removing
- Unclip lid trim (handle is secured with a bolt).
- Unclip pull lever for lid lock (operating rod for central locking system if necessary), pry out locking clamp and remove lock cylinder housing from grip plate.

11 - Rod clip
- For lid lock

12 - Rod clip
- For actuator