Power Steering Fluid: Testing and Inspection

Power steering oil level, checking
- Do not start engine but bring front wheels to straight-ahead position.

Oil in cold condition:
- Remove cap.
- Clean dipstick with a clean cloth.
- Screw cap on hand tight and unscrew again.

Note: The cap must be fully screwed in order to obtain an accurate fluid level reading.





- Check oil level: The oil level must be in area of MIN. marking (up to 2 mm above or below marking).
Oil at operating temperature (above approximately 50°C):
- Check oil level: The oil level must be between MIN. and MAX. marks.

Note:
^ If the fluid level is above the area specified, the excess fluid must be extracted.
^ If oil level is below afore mentioned area, then the hydraulic system must be checked for leaks. It is not sufficient to top-off with oil.
- Fault finding, Steering gear; No. 10; Faults in power steering