With Manufacturer Scan Tool

Check DTC Memory (Function 02)


NOTE: The VAG 1552 Mobile Scan Tool (ST) can be used instead of the VAG 1551 Scan Tool (ST), however a print-out is not possible.


- Connect VAG 1551 scan tool. Refer to "Selectable Functions When Using VAG 1551", under "Restraint Systems", Scan Tool Connecting and Initial Checks
- Initiate On Board Diagnostic (OBD). On Board Diagnostic (OBD), Initiating Program
- Switch printer on with "PRINT" button (warning lamp in button lights up).

Indicated on display


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -2- to select "Check DTC Memory" function 02.

Indicated on display


Rapid data transfer Q
02 - Check DTC Memory


- Press "PRINT" button.
- Press -Q- button to confirm input.

Indicated on display (number of stored DTCs)


X DTC recognized ->


The stored DTCs are displayed and printed out one after the other.


If a DTC is recognized:

- Repair malfunction.
- Erase DTC Memory (function 05).
- Check DTC memory again (function 02).

Malfunctions printed out can be repaired with the aid of the DTC table. Central Locking System

The function "Read Measuring Value Block" and display group overview are additional aids.

Reading
Evaluating Measured Value Blocks

The measuring value block is divided into 10 display group numbers. The assignment of the individual display fields can be found in the display group overview.

Indicated on display


No DTC recognized ->


If "No DTC recognized " is indicated on display, press -> button to return to "Select function XX" prompt.

Indicated on display


Rapid data transfer HELP
Select function XX


If something else is displayed:
See Scan Tool (ST) operating instructions.

- Press buttons -0- and -6- to select "End Output" function 06.

Indicated on display


Rapid data transfer Q
06 - End Output


- Press -Q- button to confirm input.

Indicated on display


Rapid data transfer HELP
Insert address word XX


- Switch ignition off.
- Disconnect scan tool from Data Link Connector (DLC).