ABS - ITT Mark 20 IE

Diagnostic Trouble Code (DTC) table

Note on DTC table:
- When beginning OBD of the vehicle control modules, always start with function "Automatic test sequence" by pressing keys 0 and 0 because the control modules are interconnected with a data bus wire. This checks the DTC memories of the control modules in the vehicle.
- All the possible DTCs which can be recognized by the ABS control module -J104- and printed-out on V.A.G. 1551 or VAS 5051.
- DTC appears (in the "Rapid data transfer" mode) only on the print-out.





Example:

- The 5-digit P code which may appear next to the DTC, is for use with the On Board Diagnostic (OBD) II and may be disregarded.
- The 3-digit DTC type code is a data code and may be disregarded, but the DTC type text is of use.
- Before replacing components indicated as being faulty, check all the appropriate connectors, wiring and Ground connections using the wiring diagram
- On completion of repairs always check the DTC memory with V.A.G. 1551 Scan Tool or the tester VAS 5051 and erase.
- Carry out road test exceeding 20 km/h (13 mph).
- After the road test check DTC memory again.