Pedal Cluster, Assembly Overview

Pedal cluster, assembly overview






1. Mounting bracket
Before removing, detach steering column from steering gear. Refer to Steering and Suspension - Steering - Steering Column - Service and Repair - Procedures Service and Repair

2. Pivot pin for clutch and brake pedal
3. Locking clip
4. Hex socket head bolt, 25Nm
5. Brake pedal
Maintenance free bearing; do not lubricate

6. Clutch pedal switch

7. Clutch pedal
Removing and installing, refer to Clutch Pedal and Over-Center Spring

8. Pin
Always replace

9. Locking clip

10. Master cylinder
Removing and installing, refer to Service and Repair
Seal -arrow- must not be removed

11. Hexagon socket head bolt, 20 Nm

12. Mounting
Insert in mounting bracket with over-center spring
Installation position: deep groove faces downward

13. Over-center spring
Remove and install with clutch pedal Service and Repair

14. Hex socket head bolt, 5 Nm
To secure clutch and brake pedal pivot pin
Tighten only after locking clips -item 3- and -item 9- are in position

15. Securing clip
Holds clutch switch in adjusted position

16. Torx screw, 25 Nm
Also secures the brake master cylinder with brake servo