ATF Lines, Removing and Installing

ATF lines, removing and installing





1. Hex boll, 20 Nm
- Before tightening bolt, push in pipe onto stop by hand
2. ATF pipe
- To cooler
- Note inscription on transmission
3. ATF pipe
- From cooler
- Note inscription on transmission
4. O-ring
- Insert with ATF
- Always replace
5. O-ring
- Insert with ATF
- Always replace
6. Hex bolt, 5 Nm
- Before tightening bolt, push in pipe onto stop by hand
7. O-ring
- Insert with ATF
- Always replace
8. Hex bolt, 5 Nm
- Before tightening bolt, push in pipe onto stop by hand
9. Union nut, 30 Nm
10. Bracket
11. Hex bolt
- To remove and install ATF lines it is not necessary to remove bolt.
12. Hex nut, 5 Nm
13. Clamp
14. Bracket
- On engine/transmission support