Check Control Module Version (Function 01)

Check Control Module Version

- Connecting Scan Tool.
- Initiating On Board Diagnostic (OBD).

- Switch on ignition.
- Press key -1- for "Rapid Data Transfer" mode.
- Switch on printer with Print button (warning lamp in button lights up).
- Press keys -0- and -1-.

Indicated on display


Rapid data transfer Q
01 - Check control module version


- Confirm with -Q- key.

The control module identification will be shown on the VAG 1551 Scan Tool display, e.g.:


3B1959760XX Seat adjustment FS0001->


Breakdown of display:
- Part No. of control module
- System designation: (XX seat adjustment DS 0001)

- Press -> key.

Indicated on display


Rapid data transfer HELP
Select function XX


NOTE:
- If one of the malfunction messages opposite appears in the display, the possible causes of the malfunction can be printed out with the HELP key.


Rapid data transfer HELP
Control module does not answer!


- Ignition must be switched on.


Rapid data transfer HELP
K wire not switching to positive!


- Malfunctions have occurred at the start of or during the program (external interference ?).


Rapid data transfer ->
No signal from control module!


- Check diagnostic cable as well as voltage supply and Ground connection.


Rapid data transfer ->
Fault in communication build up


- Press keys -0- and -6- to end the output.

Indicated on display


Rapid data transfer Q
06 - End output


- Confirm with -Q- key.

Indicated on display


Rapid data transfer HELP
Enter address word XX


- Switch off ignition.
- Disconnect connector to VAG 1551 Scan Tool.