Test Table Overview

Test table
Notes for test table
^ The socket designations of the VAG1598 test box are identical to the terminal designations of the ABS control module (w/EDL) -J104- in the wiring diagram.
go to Electrical Wiring Diagrams, Troubleshooting & Component Locations
^ If the measured values do not match the specifications, carry out the corrective actions on the right side of the table.
go to Electrical Wiring Diagrams, Troubleshooting & Component Locations
^ Use the VAG1594 connector kit for continuity tests (bridging).
^ If measured values differ only slightly from specified values, clean sockets and connectors of the testers and test leads (using G 000 700 04 contact spray) and repeat test. Before replacing the relevant components, check wires and connections and also repeat resistance measurement at component, especially for specified values under 10 ohms.