Rear Bumper Cover, Assembly Overview

Rear Bumper Cover, Assembly Overview

NOTE: Slight changes may have to be made to removal and installation procedures, depending upon equipment installed in vehicle.







1 - Rear bumper cover
- Material - PP/EPDM

2 - Guide piece
- To remove and install, pull out/slide in bumper cover parallel out of guide pieces (left and right sides)

3 - Bolt
- Qty. 8 (for common models Golf/Jetta)
- Qty. 10 (for Jetta GLI Sport)
- 1.5 Nm

4 - Mounting strip
5 - Bolt
- Qty. 4
- 6.6 Nm

6 - Impact strip
- For common models Golf/Jetta: clipped in cover
- For Jetta GLI Sport: delivered as by-pack
- It is not necessary to remove when removing cover.

7 - Bolt
- 6.6 Nm
- Only on Jetta models