Transmission Mount: Adjustments

Engine and transmission mounts, aligning

CAUTION:

- Engine and transmission must be supported by 10-222A engine support bridge before loosening bolts.

Engine mount assembly






a = 14.0 mm (0.55 in.)
b = minimum 10.0 mm (0.40 in.)
Bolt heads -1- must align with edge of mount -c-.

Transmission mount assembly






Edges -a- and -b- must be parallel.

Tightening torques
















Engine/transmission mounts Tightening torques

Engine mount assembly






1. Mount to body 1)
- 40 Nm (30 ft. lbs.) + 90° (1/4 turn)

2. Mount/bracket to body
- 25 Nm (18 ft. lbs.)

3. Mount to engine bracket 1)
- 60 Nm (44 ft. lbs.) + 90° (1/4 turn)

1) Always replace

Transmission mount assembly






1. Mount to body 1)
- 40 Nm (30 ft. lbs.) + 90° (1/4 turn)

2. Mount to body
- 25 Nm (18 ft. lbs.)

3. Bearing on transmission case 1)
- 60 Nm (44 ft. lbs.) +90° (1/4 turn)

1) Always replace

Pendulum support






1. Pendulum support to transmission 1)
- 40 Nm (30 ft. lbs.) + 90° (1/4 turn)

2. Pendulum support to transmission 1)
- 40 Nm (30 ft. lbs.) + 90° (1/4 turn)

3. Pendulum support to engine/transmission 1)
- 20 Nm (15 ft. lbs.) +90° (1/4 turn)

1) Always replace