Oil Seal For Right Flanged Shaft, Replacing

Oil seal for right flanged shaft, replacing
Special tools and equipment





^ 3158 Drift sleeve
^ VAG1331 Torque wrench or equivalent
^ VAG1332 Torque wrench or equivalent

Removing
^ Transmission is mounted in vehicle.
^ If installed, remove center and right part of insulation tray below engine/transmission.
^ Turn steering to right onto full lock stop.
^ Remove drive shaft.
^ Remove flanged shaft securing bolts by threading two bolts into flange and counterhold flanged shaft using a lever.
^ Place container under transmission.
^ Remove flanged shaft with spring.
^ Pry seal out with lever.

Installing





^ Drive new seal in onto stop, do not tilt seal when doing this.
^ Fill space between sealing lip and dust lip with grease G052 128 A1.
^ Insert flanged shaft.
^ Secure flange shaft with countersunk bolt and tighten to specified torque.
^ Install drive shaft.
^ Connect ball joint to control arm using new bolts at old impression marks
^ Install wheel.
^ Check transmission oil.
^ Install sound insulation tray.
Tightening torques
Flanged shaft to transmission (conical head bolt) 25 Nm