Removing and Installing

Brake Booster, Removing And Installing
Special Tools And Equipment Required





^ 3094 Hose clamps or equivalent

Additional Information

Removing
- Note or request radio code on vehicles with coded radio if necessary.
- Disconnect battery.

Vehicles With Manual Transmission
- Clamp clutch master cylinder supply hose with special tool 3094 or equivalent.
- Remove clutch master cylinder supply hose from reservoir.

All Vehicles
- Remove ABS control module and hydraulic unit. Refer to Hydraulic unit/ABS control module, removing and installing.
- Disconnect vacuum hose from brake booster.

Vehicles With Automatic Transmission





- Remove connector -1- from retainer -2-.
- Separate connector -1-.

All Vehicles
- Remove trim below instrument panel.





- Remove bolts -1-.
- Remove cover -A-.





- Remove connecting plate between clutch and brake pedals on vehicles with a manual transmission.
- Remove brake light switch -1-.
- Separate brake pedal from brake booster. Refer to Brake pedal to brake booster, disconnecting and connecting.
- Guide brake booster with brake master cylinder out forward and remove.

Installing
Install brake booster in reverse order of removal.
- Adjust brake light switch.
- After installing, bleed brakes and clutch.