Removing and Installing

Brake Pedal, Removing And Installing
Additional Information
^ ABS, ABS/EDL On Board Diagnostic (OBD) refer to Powertrain Management; Computers and Control Systems.

Removing
- Remove trim below instrument panel.





- Remove screws -1
- Remove cover -A-.





- Remove connecting plate between clutch and brake pedals on vehicles with a manual transmission.
- Remove brake light switch -1-. Refer to Brake pedal, assembly overview.
- Disconnect accelerator cable.
- On vehicles with accelerator pedal position sensor, release connector below instrument panel.
- Disconnect brake pedal from brake booster.
- Remove hex nuts, item -2-.
- Remove pedal cluster.
- Remove brake pedal.

Installing
Install in reverse order of removal.
- Adjust brake light switch.