Trunk / Liftgate Motor: Service and Repair

1 - Lock cylinder housing
2 - Handle
3 - Rear lid release switch
4 - Rear lid
5 - Lock
6 - Hex nut
- 7 Nm (62 in. lb)
7 - Linkage lever
8 - Rear lid release motor
- Removing:
- Remove rear lid trim.
- Disconnect wiring from motor.
- Unclip actuator rod -11- from lock.
- Unclip actuator rod -13- from lock cylinder.
- Remove hex nuts -10- and remove bracket -12-.
- Remove rear lid release motor from bracket.
9 - Linkage lever
10 - Hex nut
- 7 Nm (62 in. lb)
11 - Actuator rod
- Press linkage lever -9- against stop on motor -8- and hook in actuator rod without tension
12 - Support bracket
13 - Actuator rod
- Press linkage lever -9- against stop on motor -8- and hook in actuator rod without tension
14 - Bolt
- 7 Nm (62 in. lb)
15 - Bolt
- 7 Nm (62 in. lb)
16 - Rear lid release switch