4 Speed Automatic 01M, Locking Cable, Adjusting

Locking cable, adjusting

WARNING: The description below for the adjustment of the locking cable must be strictly adhered to.

Adjustment requirements:
- Locking cable correctly fitted
- Center console removed.
- Selector lever in position "P"
- Ignition key withdrawn.

Adjustment sequence:






- Slide sliding sleeve -1- forward.
- Release clip -2- by pressing upward.





- Pull off connector -4-.
- Remove sleeve -5- upward.
- Release selector lever housing cover at retaining tabs -6- (Qty. 4) by hand and lift off.
- Carefully pry off four corners of frame -7- and remove.





- Slide 0.8 mm feeler gauge between locking lever and selector lever roller.
- Pull locking cable outer sleeve lightly forward in direction of travel -arrow 1- and push red clip downward until it engages -arrow 2-.
- Push sliding sleeve over clip.
- Check operation of ignition key withdrawal lock.