Recirculating Valve For Turbocharger -N249-, Checking

Recirculating valve for turbocharger-N249-, checking

Special tools, workshop equipment, testers, measuring instruments and auxiliary items required
^ Hand multimeter V.A.G 1526 or multimeter V.A.G 1715
^ Adapter set V.A.G 1594

Test conditions
^ Carry out Output Diagnostic Test Mode.

Test sequence
- Switch off ignition.
- Pull connector off recirculating valve for turbocharger (N249).
- Measure resistance between valve contacts. Specification: 27 to 30 ohms

If the specification is not obtained:
- Replace turbocharger recirculation valve (N249).
- Check DTC memory.
- Read out readiness code.
- If the DTC memory has been erased or the engine control module separated from the permanent positive, the readiness code must be generated again.