Ribbed Belt Pulley With Freewheel, Removing and Installing

Ribbed Belt Pulley With Freewheel, Removing And Installing

Installing ribbed ribbed belt pulley with freewheel

Special tools, testers, measuring instruments and auxiliary items required







- VAG 1332 Torque wrench (40 - 200 Nm)







- 3400 Multi-spline adapter

- First remove existing ribbed belt pulley.
- Insert multi-spline adapter 3400 in freewheel disc.
- Screw freewheel disc by hand onto generator drive shaft onto stop.

The torque wrench must be rearranged before installing the freewheel disc as follows:







- Release socket drive -1- and pull off grip -2-.
- Turn torque wrench grip -2-through 180 ° and reinsert socket drive.
- Set wrench direction of turn on socket drive to anti-clockwise.
- Set torque wrench tightening torque to 80 Nm.
- Fit 6 mm socket onto generator drive shaft.







- Counter-hold multi point key 3400 with 17 mm ring spanner and tighten freewheel disc to 80 Nm by turning generator drive shaft anti-clockwise with torque wrench.
- Clip protective cap onto freewheel disc.